MTH Electric Trains PA B-Unit Specifications download pdf (Page 27)

CV1

CV2

CV3

CV4

CV5

CV8

CV17

CV18

CV19

CV21

CV22

CV23

CV24

CV25

CV29

CV52

CV53

CV54

CV55

CV63

CV64

CV66

CV67-

CV94

CV95

CV105

CV106

CV115-

CV170

Short Address: 1-127 are the valid addresses

Start Voltage (CV52, bit0 must = 1. This will enable PWM Mode)

Acceleration Rate (CV52, bit0 must = 1. This will enable PWM Mode)

Deceleration Rate (CV52, bit0 must = 1. This will enable PWM Mode)

Max Voltage (CV52, bit0 must = 1. This will enable PWM Mode)

MFG ID. MTH =27. Also used for various resets.

High Byte of Extended Address

Low Byte of Extended Address

Consist Address (bit 7=1 on an engine will tell the engine it’s reversed

in a consist)

Defines active Function F1-F8 for the active consist

Defines active functions for FL and F9-F12 for the active consist

(bit 0=1 will tell an engine that you want it’s FL control to operate under

the consist address – bit1-0/bit2=1 will configure the FL control for a

reversed engine in a consist)

Consist Acceleration Rate

Consist Deceleration Adjustment

Speed Table Select

Decoder Configuration

MTH PWM Mode Configuration

MTH Acceleration (1/8 *sMPH/s). For example - a Value of 8 written

would give you 1sMPH/s acceleration

MTH Deceleration Rate (1/8*sMPH/s)

Factory Address Reset Alternate method. Send a value of 55 to CV55 on

address 55 and the model will go back to the Factory Default Address.

MTH Consist Acceleration Rate (1/8*sMPH/s)

MTH Consist Deceleration Rate (1/8*sMPH/s)

Forward Trim(CV52, bit0 must = 1. This will enable PWM Mode)

Speed Table Selection (CV29 bit 4 must be set to 1 then CV25 must be

set to 0 or 1)

Reverse Trim (CV52, bit0 must = 1. This will enable PWM Mode)

User ID #1 – General Purpose use for customer

User ID #2 – General Purpose use for customer

MTH Function Assignments – See table of supported CV’s and manual

section on how to re-arrange them for further information

Note: The engine address has to be something other than address 55 (see pg. 23)

Configuration Variables (CV)

Configuration Variables used on MTH PS3.0-equppied engines.

M.T.H. HO Alco PA/PB Diesel Engines

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 44 45

Comments to this Manuals

No comments

MTH Electric Trains PA B-Unit Specifications Page 27

Comments to this Manuals

Related products and manuals for Toys & accessories MTH Electric Trains PA B-Unit