MTH Electric Trains Genesis Diesel Locomotive Operations Instructions download pdf (Page 6)

RailKing Genesis Operating Manual

like the Lionel® Railsounds® No. 5906 Bell Button, by simply pushing the

button. If you don’t have a separate bell button, the bell can be controlled

through your transformer’s whistle button whenever the engine is in

NEUTRAL. The bell will never ring continuously in RESET (Remember

NEUTRAL is the state between Forward and Reverse). Once the bell is

turned on, it will continue to ring when the engine is cycled into forward or

reverse until you press the bell button or re-enter NEUTRAL and turn the

bell off with the whistle button.

In fact, because of ProtoSounds® state-of-the-art design, the

microprocessor remembers its last command. Therefore, unless you turn

the bell off before you quit running your train, the next time you run the

engine, the bell will come on. No matter whether you come back an hour

later or a year later, the bell will begin chiming once the engine enters one

of the three directional states.

To turn the bell on using the transformer’s whistle button, turn on power to

the track and cycle the engine into NEUTRAL. Turn the throttle to 8 volts

or less (any higher voltage will arm the ProtoCoupler) and press the whistle

button. The bell should begin chiming. To turn the bell off, press the

whistle button again. If you want to keep the bell on while running the

engine, simply interrupt the power with the transformer throttle or the

transformer directional switch and enter forward or reverse.

PROTO-COUPLER™ OPERATION

Your RailKing Genesis ProtoSound-equipped locomotive has two

coil-wound ProtoCouplers™ for remote uncoupling action. The couplers

are mounted on the power trucks. Because the ProtoCoupler is controlled

through ProtoSound’s microprocessor, it doesn't require an uncoupling track

section or modification to your layout to function. The three simple steps

below are required to operate the coupler.

1. Put your engine in NEUTRAL and turn the throttle all the

way up.

2. Press the transformer whistle button to “Arm" the coupler.

(You will hear a “Clank")

3. After arming the coupler, press the

whistle button again to open the

coupler.

H H

Put Engine In Neutral

At Full Power

Press & Release

The Whistle Button

Press & Release

The Whistle Button

Listen For The

Ca-Clunk Sound

See The Coupler Open

And Listen For The

Cha-Chusshh Sound

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Comments to this Manuals

No comments

MTH Electric Trains Genesis Diesel Locomotive Operations Instructions Page 6

Comments to this Manuals

Related products and manuals for Toys & accessories MTH Electric Trains Genesis Diesel Locomotive