MTH Electric Trains Genesis Diesel Locomotive Operations Instructions download pdf (Page 5)

RailKing Genesis Operating Manual

system, transformer and engine are operating correctly. This takes

approximately 2.2 seconds during which you will hear the engine’s startup

sounds begin. In order for ProtoSounds to properly initiate the system

check, do not advance the transformer throttle past 10 volts when you first

enter RESET, wait for the diesel startup sounds to begin and then slowly

turn the transformer throttle to the off position and then back on again to

enter the forward phase. Interrupting the power too quickly may cause the

system to re-enter RESET (signaled by two dings of the bell). Should this

happen, wait longer before interrupting the power to enter the Forward

phase.

ProtoSounds® comes with several programmable functions, including

Engine Volume Adjustment, Separate Bell Button Operation

(pre-programmed at the factory), Cab Chatter On/Off Control, ProtoCoupler

On/Off Control and Horn-In-Neutral Operation. Each of these features are

described in more detail later. You will notice that when in RESET, your

engine will not respond to the whistle button with a horn blast or continuous

bell ringing. In fact, when in RESET and the whistle button is depressed,

only one single bell chime will be heard each time the whistle button is

pressed. If you don’t want to configure or change your locomotive using

any of these programmable features, simply leave RESET and wait 2.2

seconds before interrupting the power to put the engine in forward. After

you leave RESET, your engine will operate normally in all the direction

states of forward, neutral and reverse.

HORN OPERATION

Your RailKing Genesis ProtoSound-equipped engine is equipped with a

digital recording of a diesel horn. The horn sound can be activated anytime

the engine is in forward or reverse by pressing the whistle button on your

transformer. The horn will continue to blow as long as the whistle button is

depressed. The horn will not function in RESET and must be configured

through a RESET option to allow the horn to work when the engine is in

neutral. See page 17 for information on horn programming in the Using

RESET To Program ProtoSounds® section of this manual.

BELL OPERATION

Your RailKing Genesis ProtoSound-equipped engine is equipped with a

digital recording of an actual diesel bell. Unlike previous versions of

ProtoSounds, the bell can be turned on or off with any separate bell button,

1 2 3 4 5 6 7 8 9 10 ... 39 40

No comments

MTH Electric Trains Genesis Diesel Locomotive Operations Instructions Page 5