MTH Electric Trains E-33 Operations Instructions Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
13
E-33 Rectifier Operating Manual
and release the whistle button. Interrupt the transformer throttle to enter the
next directional state (either forward or reverse). (Note: the FYS will only
play in the first Neutral after it is armed. You can not interrupt the power
twice to enter another direction and still have the FYS active.) You can
now trigger the sounds to begin playing when you next enter Neutral.
TRIGGERING FREIGHT YARD SOUNDS
Once the FYS feature has been activated, it will be played the next time
the engine enters neutral. At this point, Proto-Sound® will take over
control of your engine, disabling the bell and whistle button. In addition,
Proto-Sound® reconfigures the way the reverse unit functions during the
operation of the FYS feature. This forces the engine to leave your Freight
Yard in the same direction as it arrived. The following operator controlled
“Events” control the FYS’s actions and sounds. (Note: The direction states
shown assume the FYS is entered from forward. If entering the Freight
Yard in reverse, the direction states shown will be reversed.)
Event 1: Interrupt the transformer throttle to cycle the engine from forward
into neutral. If the throttle was at 14 volts or higher, the squeaking brakes
sound will play. Once the engine is stopped, the throttle must be turned on
to keep it in the neutral state. Note: Failure to turn the throttle back on
within 3 seconds of leaving forward will disable FYS and shutdown
Proto-Sound®. The next time power is turned on, the engine will be in
the RESET position. See page 23 for additional
information on RESET. If the bell
was not turned off after arming FYS, it
is now turned off automatically. After
entering neutral, Proto-Sound will
immediately play a horn blast or an air
release sound, followed approximately
2 seconds later by a man whistling and
a freight car door sliding open. At this point, various freight yard sounds
can be heard, including loading and unloading operations, engine sounds,
yardman “slang,” and additional freight car door sounds.
Event 2: Interrupt the transformer throttle again to cycle the engine from
neutral into reverse. In order to have the engine leave the yard in the same
direction it entered Proto-Sound® disables the motors in this reverse state to
prevent the engine from running backwards. FYS confirms reverse is
Listen For Air Release Sound
And Cab Chatter Message
Put Engine In Neutral
At Low Power
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Comments to this Manuals

No comments