MTH Electric Trains Genesis Diesel Locomotive Operations Instructions download pdf (Page 16)

RailKing Genesis Passenger Set with Proto-Sound® 2.0

Volume Remedy

The sounds seem distorted, especially when

the Horn or bell is activated.

No Sound

Proto-Sound 2.0 volume is set too high. Turn the

volume control knob on the bottom of the chassis

counter-clockwise to reduce the volume.

Volume is set too low, adjust volume control knob

on the bottom of the chassis clockwise to increase

the volume or check connector to speaker.

Battery Remedy

The engine will not leave the initial neutral

setting.

I get no sounds when the engine shifts

between directions.

After I turn off my transformer, my engine

continues to make sounds before quitting.

Check to be sure the battery is installed and fully

charged. See the "Self-Charging Battery Back-

Up" section.

The battery may be dead or need to be charged.

See the "Self-Charging Battery Back-Up" section.

Proto-Sound 2.0 is designed to continue to sound

for a few seconds after power to the track has

been shut off to allow for a more realistic shut-

down.

Lock-out Remedy

I can't get the engine to run after I power up

the transformer. It sits still with the diesel

and compressor sounds running.

The engine won't lock into forward, neutral,

or reverse.

The engine maybe locked into the neutral

position. Follow the procedure in the "Lock into a

Direction" section to unlock the engine's direction.

Engine speed must be below 10 scale mph

(approx. 10 volts or less in conventional mode).

PSA Remedy

Once in PSA, the engine doesn’t go into

reverse.

When the PSA enters its last sequence the

bell automatically comes on

When PSA is enabled, pressing the whistle

and bell has no effect

I push the direction button but the next

sound clip in the sequence does not play or

the engine does not come out of PSA after

fourth press of the direction button.

So that PSA effects can be as realistic as

possible, Proto-Sound 2.0 disables the

reversing unit whenever PSA is enabled.

This way the engine remains still at its stop

as the operator cycles through the PSA

sequences.

PSA is programmed to start ringing the bell

at that point. After approximately 12

seconds, it will automatically turn off.

Because PSA must control various effects in

each sequence, Proto-Sound 2.0 takes

control of these sound effects until you exit

PSA

Each PSA clip must play for aprox. 30

seconds before PSA will advance to the next

step in the PSA cycle. Wait at least 30

seconds in each PSA sound clip before

pressing the direction button.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 26 27

Comments to this Manuals

No comments

MTH Electric Trains Genesis Diesel Locomotive Operations Instructions Page 16

Comments to this Manuals

Related products and manuals for Toys & accessories MTH Electric Trains Genesis Diesel Locomotive